Posted by steve_in_mo on May 22, 2021 at 19:29:24 from (71.1.110.197):
In Reply to: Building a dock posted by chuck t on May 22, 2021 at 18:43:23:
I live on a lake, and a big tree fell on my old cedar deck after a storm. It had styrofoam blocks for floats. The styrofoam floats are no longer legal - can't be re-used.
I built a new deck using commercial (blow-mold) manufactured floats. It's a lot like building a hayrack only with 2x8 and 2x10 lumber. Most of the neighbors have a deck like mine but a few have bought commercial steel-frame decks. The commercial steel frame decks use galvanized steel for the frame and have legs going down into the lake bed. No floaters. I suspect your mobile home frame will rust out more quickly than your steel barrels.
A couple of neighbors have used the heavy plastic food-grade barrels for floaters on a treated pine frame. They seem to hold up well.
I used composite decking for the surface on top of a treated pine frame. A neighbor built a deck similar to mine only using treated pine decking. They are both eight years old this summer and both holding up well.
The manufactured floats can go flat or suffer other damage. I currently have one that has lost its ability to hold up its corner of the dock.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
