Posted by rustred on June 01, 2021 at 14:12:45 from (74.214.153.210):
In Reply to: Why do floats stick posted by SDE on June 01, 2021 at 10:47:27:
well these tractors came with a fine screen that sits in the top of the sediment bowl under the gasket. plus there is another screen at the carb inlet. and thats it, there is no screen on the stand pipe in tank. so that means with those two screens there is no reason to worry about junk getting in the needle valve. its been that way since the tractors were new. first thing that happens is people throw away the sediment bowl screen. only the bigger stuff will settle out in the bowl. the rest goes straight to carb screen which was the secondary catch screen. technically anything going through that screen will not cause needle valve trouble. as your needle valve and jets are bigger. there is no reason to be closing the sediment bowl valve just because your thirsty. closing the valve is for when tractor will be sitting for long periods. so if gremlins did that you dont have your proper screens in place. plus on the cap it says buy clean fuel keep it clean. plus any rust in the tank is not the tractors fault. i am sticking to my tryed and true method.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
