Posted by showcrop on June 10, 2021 at 04:13:54 from (75.68.37.174):
In Reply to: Windrower posted by Bobl1958 on June 09, 2021 at 09:38:43:
Bob, whether or not you need a crimper or not is HUGE, but it depends on where you are and what your ground is like. Here in the Northeast there is often a lot of moisture in the ground into August. This dictates that we make hay in a very different way from those who are on dry ground. It makes no difference whether we use a mower or a swather we have to put it into a narrow swath or we are driving on it after it is cut and pressing it down into the soft ground-not good for drying. As others have said we need to crimp it or it won't dry quickly enough for the good weather stretch that we have before the next rain. We also need to ted the swaths out after 4-6 hours of letting the ground dry out. If you are on dry ground that mower will work as well as your swather. As to the round and round part, as others have said we go around 5-6 times until the corners get tight, the strike off lands that are usually around 100 to 150feet wide and go back and forth. Yes, you will mow much faster without plugging and you will have the capability of getting twice as much hay rained on as you did with the sickle bar mower.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.