Posted by used red MN on June 21, 2021 at 22:44:20 from (75.73.112.20):
In Reply to: Ammeter??? posted by db0941 on June 21, 2021 at 16:59:05:
Hello db welcome to YT! Steve@advance and Buickandeere have good descriptions of what the connections should be. The link Steve gave to the diagram takes you to a multiple return search result so that is a little confusing. I will direct link his top diagram. Your M will differ if it in stock configuration because instead of a solenoid it will just have a heavy contact switch that energizes the starter, most are operated by a foot lever just to the left of the brake pedals. So in the diagram place that switch in place of the solenoid and you will not have the starter button that would energize the solenoid. Main thing is as was described, one side of the ammeter will go directly to the post on the foot switch where the battery cable that come from the positive cable connects and that will be the only wire connecting on that side of the meter. The wording for the ..solenoid wiring starter button.. is placed in that diagram so it is a little confusing just disregard it and follow the wire connections as shown. And also as pointed out the starter motor amperage does not go through the ammeter. If you make the connections and the gauge reacts backwards as the alternator shows a discharge when running and the light draw shows a charge you just need to swap your wires side to side on the ammeter. Hope this helps to clarify the answers to your question.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
