Posted by Destroked 450 on June 28, 2021 at 09:35:12 from (66.38.93.182):
Some of you may remember the Montana/Farmtrac tractor I build last fall using a Ford 3930 engine along with Ford hydraulic and power steering pumps
It has proved to be a great little haying tractor and has been part of out haying operation this year
Well Friday after only 47 hours of use the new water pump we had installed during the build failed. The 3930 engine had been setting in the shop for 6-7 years and the tractors engine had been disassembled for 4 years so I didn't trust either of those water pumps and decided to go with a new aftermarket
Due to a ongoing project taking up my small one bay shop I'm outside in the sun with 89 degree temp and 67% humidity sweeting my behind off
But we'll get it going after a bit of lunch and a dry shirt, still have 600+ rolls in the fields to load haul out
This post was edited by Destroked 450 on 06/28/2021 at 09:49 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
