Posted by MarkB_MI on June 30, 2021 at 08:01:17 from (174.211.6.240):
In Reply to: euclid equipment? posted by swindave on June 30, 2021 at 04:07:20:
GM bought Euclid back in the fifties, but was forced to sell it in 1968 due to an antitrust suit. GM then formed Terex, and continued to produce many of the Euclid products under the Terex name.
My dad had a Terex/Euclid TTS-14 tandem scraper. These are relatively rare machines based on the popular TS-14 twin-engine scraper. The TTS-14 had two scraper bowls, one behind the other. The resulting 70 foot long machine had three 4-71 Detroit engines driving six tires through three six speed Allison transmissions. It was ideally suited for the sandhills of northeastern Colorado, as it could load itself without help from a push-cat. The TTS-14 could do the work of two 14 yard scrapers and a push-cat, yet only needed a single operator. The transmissions and rear engines were operated through air controls, so the rear engines only had two throttle settings: idle and wide-open. The front engine had a mechanical throttle, but since its pedal was right next to the air throttle you always ran all three engines WOT.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.