Posted by INCase on July 01, 2021 at 05:35:29 from (209.221.240.193):
In Reply to: Allis WD vs Moline ZBU posted by GMDieselman1950 on June 30, 2021 at 18:34:28:
what year WD? there were some improvements (not alot) over the time they were built.
you can probably find a decent WD45 for the same $. a tad more power and a bit newer. LOTS of parts available for the WD's new and used.
the WDs are lighter for sure but have a peppy engine and are simple to work on. the WD doesn't have what I call a true live PTO. you cannot just hit a lever and engage the PTO. you have to push in the foot clutch and engage the PTO and then let the clutch out. the hand clutch on the WD lets you operate like a live PTO so keep that in mind. the WD snap coupler hitch set up is fairly easy to convert to standard 3pt hitch but could make getting on/off a bit more challenging.
I've spent alot of time in the seat of the WD45 and some on a WD. I cannot say I know much about the MiniMo's other than they are heavier built.
for small acres and the price the WD will probably do what you want. If it were myself I would probably look for a good small newer Case 430/530 or smaller Ford 3000/4000 or Oliver 55/550 but those will be a bit more $.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.