Posted by showcrop on July 03, 2021 at 15:47:34 from (75.68.37.174):
In Reply to: small bale sweat posted by mjsnodgrass on July 03, 2021 at 13:35:13:
By sweat, since of course hay does not sweat, I assume that you are asking how long will it take for it to dry down to a moisture level where it will stop molding and the temperature will drop. This is also assuming that 70lb. bales are substantially heavier than what you normally make since most small squares weigh 35 to 55 lbs. Another question to the picture is that hay needs to be down to 18% to not heat up, so a 15% reading doesn't make sense. My answer is that it will take not hours or days but weeks before the moisture can ever so slowly work its way out. When I am asked about heavy bales here locally I advise people to put them on edge with space on all five sides in order to prevent heat build up. If you want to just prevent fire you need to keep them separated so that heat can't build up. If you want to prevent mold you need to load them up and open them up on some dry ground, tedd them out and let the sun dry it.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
