Posted by Steve@Advance on July 11, 2021 at 11:54:18 from (99.190.215.237):
In Reply to: Re: STP or Lucas? posted by Geo-TH,In on July 11, 2021 at 08:50:42:
Back in '79 an old friend of mine bought a new GMC 3500 454 4 speed, started his own business hauling sail boats.
It caught on good, wasn't long he had 300,000 on the clock. The engine ran fine, but he just didn't trust it being on the road so far from home.
He had some well known local diesel mechanic build him an engine (a whole nuther story I won't go into here).
We took his old engine apart, everything was amazingly good! The plastic timing gear had some cracks and the chain was loose, but otherwise that engine could have passed for one with very low miles miles!
It had always had Castrol 10w30 and a pint of STP at every oil change, changed every 3000 miles.
It had also had a hard life, hours of idling with the AC on as he always took his dog with him, miles of heavy throttle, over revved being stuck on slick boat ramps...
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
