Hard to start, how? Describe the starting process.
Hard to start can mean a lot of things. Many tractors pop right away but will not stay running and require several attempts to get the fuel air mixture right so it will stay running. Others just crank and crank with no response.
Is he using the choke? Most gasoline tractors need at least some application of choke when starting cold. They are not fuel injected. Every tractor is a little different, and you have to figure out what your tractor wants to start first time each day.
Only running the tractor once a year doesn't help.
Did he confirm lack of spark before messing with the points previously, or did he just start sawing away on the points any time it would not start?
Get a fifth spark plug and pull one plug wire while trying to start the tractor. The tractor will fire and run on three, and you can observe the plug for weak spark as he is cranking the engine. 6V does not leave much power for a good spark with a dragging starter.
After confirming good spark while cranking, get a can of starting fluid and spray some in the intake while cranking. If it fires right away you have a fuel problem. Starting fluid is not all ether, will not hurt your engine, and will not make your engine "dependent" on it.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
