Posted by BarnyardEngineering on July 28, 2021 at 05:42:03 from (161.69.121.33):
In Reply to: Tractor rops/canopy posted by JayinNY on July 27, 2021 at 17:17:26:
Quoting Removed, click Modern View to see
Jay, there is a program that pays 70% of the cost of the ROPS (just the roll bar, you are responsible for the cost of the caonpy top) if you are a farmer. ROPSR4U is the website.
Iron Bull is one of only a couple of companies building approved ROPS that the program will reimburse you for.
There are some hoops to jump through. You have to get a quote then pre-approval, then order it on your credit card, then install it, then provide proof that you installed it before you get reimbursed.
I signed up for the program last year but there was no funding due to what all was going on at the time. There was funding this year but I'm not sure if there is any left at this point. I signed up again but circumstances have prevented me from following through. They are really nice folks to deal with.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
