Posted by clevepreach on July 31, 2021 at 17:28:33 from (96.18.148.253):
First post. I am excited to be on this forum. I was recently able to obtain my dad's 1963 John Deere 3010 which he bought new in 1964 (left over inventory). He sold it to a neighbor in about 1992. The neighbor passed away earlier this year and I was able to buy the tractor from his partner. Dad grew up on a share cropper farm and bought his first farm in about 1952 or 53 (I was born in 59). According to what I have been told his first tractor was an A/C but I'm not sure of the size. He then bought a JD H, then a 50. I'm not sure if he traded both or just one in on the 3010 but from the H onward all his personal tractors were John Deere: 430, 520, 4010, early 4020, late 4020, and 4630 (not in sequential order). We did have a couple of IH (706, 1456) and one Ford (9000) on the farm that belonged to my brother. What I would really like to know is where I might find a hydraulic cylinder of the type that JD sold in the early 1960s. I have a JD #5 mower that I would like to use with this tractor but I don't have a cylinder to lift it. I would like to keep things as original as possible. Thanks for any suggestions.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
