Posted by steve terplak on August 04, 2021 at 14:57:54 from (174.197.198.125):
Finished baling for the day a couple days ago and noticed that my knotters didnt look right when blowing chaff off. Looked in more detail, twine had hung up in the bale hook and twine fingers didnt look right. Spring which holds the lever in place had broke. Had a spare in the toolbox, went to bale. When it was tying a knot, needles stayed in the up position, drive chain broke and broke a shear pin. Drive chain was old and worn (one side of the roller chain link appeared to be an old break. Mended the chain, returned the needles, tied a knot and the shear pin broke again. This time the needles did not remain up but they did not return all the way to the home position. I am wondering if it is an issue with the brake? Or perhaps it needs adjustment. The needles, when pulling them back to the home position move easily near home but need a little force to pull them back all the way. They remain latched there but can easily be pulled forward. I compared to our 2nd baler (NH 311). The needles on that do NOT easily move out of home position.
Should the brake be holding the needles firmly in place? I have a manual (both repair, knotter and operators) but figured i would ask what I should be feeling as far as home tightly the needles are held into the fully retracted position.
I hope my question makes sense. Thanks in advance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.