I live in KY and most of my fields are side hills-more like long ridges and shorter hills. It would not be feasible to bale up and down them. In fact I bale one hill that is so steep the tractor will barely pull the baler back out of there with no bale in it. Most all the scenarios described by the other posters apply to me as well. My steepest hills end in hollows-really 'ravines' or woods, or both, mostly: so no bale retrieval possible. And so I am careful where I eject the bale. Where I can, I drive to the top of the ridge while tying, and then eject. I have ejected on the side of a hill(more than once) and even pointed the rear of the baler uphill and had the bale take off. The hay was flying 25' out of the bale in the air and the bale was flying! What 'sometimes' will work, is while ejecting the bale, not opening the tail gate all the way and catching it as it falls out and trying to hold it in place with the tail gate, until the bottom of the bale flattens, and takes a set. Hold it there for a few moments and it 'might' stay in place. But I have even had them roll away too. Sometimes they stay in a dip along the hill, but not always: they might flip end over end. Just be careful-really plan ahead where to drop it. Mark.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Part 2 - by Anthony West. In February 1953 production of the ETC T.V.O engine started, ready for the March 1953 press announcements. The new TVO engine had a number of improvements which resulted in a 10 per cent more power (43bhp as against 38 bhp on the earlier engine) and 10 per cent more fuel economy. Some of the improvements are listed below: Redesigned combustion chamber, improved spark plugs and positioning, plug size 14mm(earlier size 18mm).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
