I have a tractor, a Massey Harris 20, and have had a few other smaller tractors over the years. Two Massey Harris 101 Jrs, A Cockshutt 30, Avery A, Allis B, Case V and a Farmall A. I've never pulled other than once fooling around at the site, but me and another fellow cut grass and keep things looking good on the property. It's all volunteer work so I have a farm to play on with no expenses ..... ha! We take two cuttings of hay off the property in the photo where we host our pull. We don't own it, the county lets us use it. I live in Sherwood Park, just 4 miles east of Edmonton. The farm is 5 minutes NE of Sherwood Park. Until this year we planted grain crops on the adjacent property also owned by the county. We now lease 50 acres for that about 3 miles east. There is a historic mansion on the top of that photo called the Bremner House, it's about 115 years old I think, county owned. We'll probably be moving or will become homeless, the county is plopping a big $80 million horse palace on the property for the well-heeled horse lovers and their families, lots of pavement with an RV park and even a polo field for those that like to ride horses and smack little white balls and pretend they live in England or wherever that is played. I didn't know anyone here even did that but apparently they do.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
