Posted by Steve@Advance on September 02, 2021 at 10:22:20 from (47.37.93.118):
In Reply to: Ford 8N RPM posted by cuby on September 02, 2021 at 09:22:14:
For sure governor problem.
Could be bad gov or link to the carb is adjusted wrong.
Disconnect the gov link from the carb, set the dash lever mid range. hold the carb at idle, start the engine.
Hold the disconnected link near the carb and slowly bring the RPM up. Feel and watch the disconnected link as it moves in the direction to push the throttle closed. Be sure to have the slack out of the linkage so you can feel the governor work. If it moves the link, note the location where it stops moving. Set the length so that position will have the carb lever pushed against the idle stop.
If no movement is detected from the governor, something is wrong with the governor. Be sure there is a spring between the dash lever linkage and the governor.
Theory of operation, the spring pulls the throttle open, the governor pushes it closed as needed to maintain desired RPM.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
