Posted by Geo-TH,In on September 11, 2021 at 12:27:32 from (50.102.16.122):
In Reply to: Re: head gasket posted by old on September 11, 2021 at 09:16:49:
BAck in the early 70's a friend had a Ford Pinto. They just came out with aluminum heads. Under warranty ford put 2 head gaskets on it. It took a 6 pack of Bud for the two of us to remove the head and put a new gasket on it. Back then I never heard of silicon gasket. It was clear silicone. HE put a very thin coat of silicone on both sides of the head gasket. We both drank a beer while silicone dried a little. One beer each to remove head, one for silicone to dry and one to replace head. Not bad for two college boys. He never had a problem with head gasket. Ford original gasket leaked and 2 other attempts to replace it failed too.. I have used copper spray. I wish I had used silicone. Had a tiny pitted area on Farmall block and the spray copper didn't fill in the tiny pit. Leaks a few drops of oil.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.