Posted by tarzont on September 19, 2021 at 12:23:37 from (72.128.38.227):
hello tractor people, I have purchased a jetstar3 industrial tractor with a backhoe and front loader, out of Pennsylvania back in March and had it shipped to Kansas. I got it running which was a great start for me. I recently discovered it needed a clutch and with the help of this forum I found the parts I needed and support to completed this job also, outside if I may add. Now when I split this tractor I had to disconnect the four power steering lines that run horizontally along side the left hand side of this tractor, and yes I marked them, BUT being outside, my marking have faded to a point that only one is connected right. I attempted to put the other three back but when I started t the tractor the steering wheel turned by it self hard left. I shut the tractor off and changed lines 2 & 3. when I started the tractor the steering wheel spun hard right, I have now damaged something in the steering column, Any help, pictures directions would be appreciated, This is a project, but I am wearing down. please help if possible. two lines go to a reservoir cannister and I believe the other to go to the front of the tractor to the steering gear box.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
