I know what your saying about the collars. These are one piece nonadjustable cheep light weight collars that hanging them on a nail would not change the top. One seller had them on ebay for a short time. I think they were from India. I am trying to get set up where i can harness the horses from my wheelchair in the barn. I can not stand to do anything without holding on with one hand or lean on something that can not move. I have no one here to help. My wife can not cook or any chores without sitting. I work the horses from the wheelchair using all the commands which keeps them. Example, Last evening I was dumping a loader bucket of chopped hay over the fence. Prancer wanted to be under the bucket and keep the other two back. Before I dumped the bucket I said, Prancer, back back up. He backed up so i could dump. A few days before I was dumping chopped hay for the thre mares I had in an earlier video. Misty was standing where I would dump on her back. I said Misty, step up. She stepped up out of the way for me to dump. I wish I was able to video these actions that give me the proof of how smart these little horses are.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
