The problem you described has the exact symptoms of a failing piston seal in the cylinder on the drill. Especially since you say it does the same thing on both sets of remotes. If you took the drill off of this tractor and hooked it to your 1100 and it works fine your point is proven. But say for instance you unhooked the drill from the 1100 or just used it on you 1100 a month ago this does not verify that the drill cylinder is working properly. Say AS AN EXAMPLE the auto canceling release pressure for the remote on the 1105 requires 500 psi more than the 1100 and the seal ring on the drill cylinder piston was worn and near failure. You connect the drill cylinder and hit the lever to raise it. Due to the fact that the 1105 applied 500 psi more to the cylinder when it hit the end of the stroke your weak piston seal has now failed. This all comes under the old saying ..trust but verify.. hope you understand what I am saying. Just trying to save you from trying to fix a problem with the tractor that does not exist. I am not an expert on a 1105 but I think the 3 position lever Bill VA has mentioned only applies to operation of the 3 point hitch. If someone knows otherwise I have learned something today.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.