Quote: CVPost-herk (quoted from post at 19:55:43 10/25/21) Hello I just bought this tractor , every thing worked fine , I hooked it up to the disk drove it a few feet and lost the steering, steering wheel locked up, tried to turn it was locked tight, it turned to the right before this happened my guess is the steering motor went out, has any one rebuilt one of these?? how expensive ?? I have one from a 145 smaller in size would this work ?? Thanks Bryan
First of all, it's a steering VALVE, not a "motor".
The "800" was made for quite a few years and the hydraulic system changed over time, (IIRC) some had a 4 port steering valve and some had a 5 port.
It would be helpful to know the serial number/year of yours.
MANY years ago a friend's 5-port valve broke internally and caused a situation similar to what you describe.
On some of the production range a failed steering pump/ stripped pump drive could cause what you are seeing.
Determining exactly what hydraulic system you have, then checking for flow and pressure available to the steering valve with a "FloRater" or equivalent SHOULD determine if it is a steering valve or hydraulic supply issue.
This post was edited by wore out on 10/25/2021 at 09:30 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
