Posted by used red MN on October 28, 2021 at 07:52:15 from (146.209.159.16):
In Reply to: 1965 tractors posted by muleman51 on October 28, 2021 at 05:48:45:
The info I found was from Tractordata.com saying a J.I. Case 830 was $6,000 for the 1969 year, so take it with a grain of salt. You mention that the 2510 shifts without grinding. That is because of the synchronized transmission ..Syncro-range.. transmission. So as the word implies during shifting the speeds of the gears were synchronized or matched by brass clutch synchronizers to avoid gear engagement grinding. Deere really had a much better design for shifting the transmission. The gears in their transmission always stayed in mesh and the shifter moved a collar with teeth to engage the gear to the shaft. Many other brands Case and IH for example just slid the gear and the actual driving gear teeth had to engage to make the gear changes. If you ever had the transmission of one of those brands open you will always see rounded and chipped teeth in the area where the teeth clash or grind to make engagement. So you can get imagine how the teeth surfaces that carry the load get comprised or damaged over time. Meanwhile the gear teeth in the Deere run along happily mating one another with no ill effects from trying to mate with the teeth from another gear moving at a different speed. Just some added info.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
