For the bucket idea, fill a 5 gal. bucket up with grain to maybe 4 or 5 inches down from top. Just let them have a feast and a ball for a few days. Keep bucket filled to that level. Then take bucket away, empty, and fill up with water, with maybe an inch or two of grain floating on top of water. Do this so its at the same level in bucket as before (4 or 5 inches down from top). Then the rats will sink through the floating grain and drowned. Pick out the dead ones everyday untill you don't catch any more. You might have to repeat the entire process and start over with a full bucket of grain again, depending on how many there is, and how clever some of them are. Note, you'll have to use grain that will float. If whats in the bin won't float then use another kind that will. Use the same kind through entire process. The oil thing, there is nothing to bait them to the bucket. It would just be an accident for them to take an oil bath. The poison thing. Use the nail down. If they can move it, they will. They'll move it back to thier nest, and use it for nest building material and won't eat it. Not enough to kill them. If its nailed down, they'll eat more of it because they can't move it. Then they'll usually eat enough to kill them. With the nail down bait, buy small supplies of it, and change kinds everytime you run out. Don't know how, but using the same kind all the time seems to loose its effectiveness. Perhaps they'll just eat more of something thats new to them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.