Posted by docmirror on November 23, 2021 at 19:50:00 from (75.3.255.251):
In Reply to: Buried farm machinery posted by Charlie M on November 22, 2021 at 06:33:35:
My sinking feeling story is not so dramatic. We have a lake house, and in about 60 feet of shoreline we had sedge grass and reeds. My wife didn't like not seeing the shore, and asked me to brush hog a clearing. I only had an 8N with new back tires. I walked it first, through the grass and reeds, and didn't note anything to concerning.
I got hooked up, and spinning and took a small cut at it, no trouble, swung a circle and took another bite across the sedge and reeds. I figured, no problem, I'll knock this down in 30 min and be back watching football and drinking beer on the Barcalounger. So - I took bigger bite right down near the shore line.
It bogged, I clutched(8N live PTO) tractor stopped dead. Unshift the PTO drive, lift the brush hog, and that was the end of that. As soon as I started to move off, the rear wheels just headed for China. Stopped when the lower rims were shipping water, and I stepped off a very short drop down.
Four hours later, I'm covered in sand, mud and two trucks and 40 feet of chain, finally back on dry land. I learned the right way to do it. Face the house, back to the shore, brush hog up, and back into the reeds. Spin the brush hog, drop it on the reeds, and catch 1st gear quick. Then move over, back down, drop it and do it again, and again.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.