Posted by docmirror on November 25, 2021 at 18:15:56 from (75.3.255.251):
In Reply to: FORD model N 1952 posted by qmlb71@hotmail.com on November 25, 2021 at 11:44:37:
I am a big fan of the early 50's 8N tractor, as I have two of them. However, as everyone else has noted I will chime in and say that the 8N is not a good platform for any kind of digging, trenching, or loading tool.
I have even stopped the 8N engine with a 12" auger before breaking the shear pin, so it's not very powerful. once you add the hyd pump, and the backhoe attachment to the back of a ~27HP engine, it's just going to bog down and make you miserable.
Start with a 641, 741, or 800 or 900 series which are all old Ford models. They will have around 40HP and up and are much more suitable to a attached backhoe.
In addition to the 8Ns, I now have an 860 and recently a 961. These are excellent farm tractors and make decent if not perfect utility or dirt tractors. Both have loaders with power steering, and I can use the auger, blade, or brush hog without worrying the engine will bog and stop.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
