Posted by Pete in Holland MI on December 06, 2021 at 18:47:34 from (199.176.232.160):
In Reply to: U-make-it ROPS posted by docmirror on December 06, 2021 at 16:45:11:
The ROPS on my 2900 lb Kubota is made of 1-1/2 x 3 tube, mandrel bent in the corners. Wall stock is about 1/4.
Manual says (paraphrased): When the ROPS is up.....wear a seat belt. ROPS down, no seat belt. With a ROPS, if you don't stay in your seat, you run the risk of being crushed by the ROPS itself. When the ROPS is down, you don't want to be strapped to the seat, as crushing is almost a given. Your best hope is being thrown from the tractor.
A lot of the strength of the ROPS is needed as the tractor rolls from being upright, to upside down. Holding a tractor upside down doesn't take too much structure.
Wander past a tractor store and compare those ROPS with a similar tractor in size & weight.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
