Posted by caterpillar guy on December 07, 2021 at 02:14:16 from (47.26.95.42):
In Reply to: U-make-it ROPS posted by docmirror on December 06, 2021 at 16:45:11:
I hate to say it but the iron everybody wants you to use would end up weighing more than the tractor when done. It's only a light little Ford of about 3000LBS. I would attach the verticals to something better though with a gusset in the bottom corner for stiffness. As for the ends sticking out my brothers 2940 has ends sticking out a wee bit like you have. I can not say if it is original or not since he bought it used and was there when he got it. You are not likely to tip it over unless the bucket is up pretty high and that will keep it from rolling over completely upside down. As for weight and size of iron they need to look at some of those old Stiegers the roll frame in those cabs must have been just for looks. I doubt if any of them would have held up under one of them rolling upside down. Those weight a good 10 times what you have. Jim is probably right about the jerking with a chain for a test though what you use to jerk the chain would have a lot to do with the durability of the frame. Say jerk with a pickup or other tractor would probably tip the tractor over anyway.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
