Posted by rockyridgefarm on December 07, 2021 at 04:32:33 from (96.61.191.22):
In Reply to: U-make-it ROPS posted by docmirror on December 06, 2021 at 16:45:11:
What were you expecting, docmirror? An attaboy? A line of people waving money at you to make them one? The responders are saying what they are saying because they care about your safety. It is up to you
I think Janichalsons suggestion on how to test it is a good one. You should be able to pull on the topmost point of that frame and lift the wheels off the ground. Anything less than a rock solid frame that doesnt flex in any way will save you from a roll over.
First thing I would have done was using heavier steel. Maybe not much heavier, considering how small a tractor you have.
Second thing is to make it shorter and narrower. That may sound counter intuitive, but a shorter frame will be less likely to collapse as it rolls. Maybe the suggestion of mounting an X inside the frame will help with that.
Not everyone is trolling you. Most want to help you survive a rollover.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
