Posted by Geo-TH,In on December 24, 2021 at 02:45:53 from (50.102.18.187):
Yesterday I finished trailblazing the road that runs south of the gravel pit. When the boss finishes her alligator work you will be able to look down about 30 ft to the bottom of the gravel pit and see a lake.
The biggest obstacle wasn't the brush, it was an 8 foot cliff, a drop off.
I worked in a confined space between trees and had to harvest dirt to fill in the drop off.
Don't think a brush hog would do much good here.
Had to use the backhoe to recover some dirt from the roots. The front bucket couldn't cut through the large roots. It would slide over the roots.
Good thing the terramite doesn't have a radiator. I smelled wood getting hot. This happens all the time. I made a skid plate to keep branches from getting to the hydraulic hoses.
After a few hours of harvesting dirt, I made the final drive to the bottom. It didn't take me long after that to connect the south rim road to the west rim road. In two days I was able to make about a quarter mile of trails. Now we have a backdoor to the gravel pit. The trail begins very close to out back door
If Larry would show up on the job site, he could earn his operators certificate. To get a certificate he must have 50 hours of supervision seat time operating a terramite.
I have to admit, I had my seat belt on.
Without a certificate, Larry can't operate a terramite.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.