Posted by Texasmark on January 18, 2022 at 06:55:41 from (99.197.208.100):
In Reply to: Re: Wood stove in shop posted by Richard G. on January 18, 2022 at 06:43:46:
I built the original 1440 sq. ft. of my house on a 36x40 grid back in 1979 and in the center was an Earth brand wood stove, vertical stack. My design of the house was specifically for heating with that stove and minimizing external exposure....functionality, not flattery. I used that stove till a couple of years ago when I decided to quit fooling with wood due to several circumstances, none of them safety related. i did sweep my 8 dia. chimney annually before the cold season.
Wood isn't all that plentiful here so some folks used 55 gallon steel drums with used oil drip to heat their shop. Get that steel hot and it radiates really well. 1600 Sq. Ft. is big but at least you can warm part of it. Only concern I have is running a horizontal pipe through a wall for venting...need to manage any conducted heat to the wall.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
