Posted by Crazy Horse on February 01, 2022 at 15:35:23 from (204.191.200.176):
In Reply to: Hard Labor On The Farm posted by aFORDable on February 01, 2022 at 12:35:34:
This isn't farm related but I'm gonna barge in here anyways. Any of you who worked on or saw big-inch pipeline construction before the factory pipe coatings came into play will remember the on-site hot tar paper-wrapped process (using wrapping machines) they used to wrap the pipe with before putting it into the ground. The pipeline tar kettles (big versions of a roofer's tar kettle) were huge, as big as a small military tank and would hold and keep melted several 45-gallon drums of tar. It would solidify when cooled and could be reheated again and made liquid. BUT if you cooked it too hot, it turned to cinder (un-meltable) and there was only one way to deal with it. Crawl in and chop it out by hand once it cooled using an axe, crow bar, hammer and chisel, pick your poison. After a day inside in the hot sun (well the lid on the top was open anyways), you were thinking about going back to school come fall time. This was in the mid-60's for me.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
