Posted by Paul Janke on February 01, 2022 at 18:59:12 from (69.163.92.122):
In Reply to: Hard Labor On The Farm posted by aFORDable on February 01, 2022 at 12:35:34:
When I was ten years old we started a fence post business. We used lodgepole pine and treated the posts with pentachlorophenol. The work in the timber was the worst part, next worse was peeling using a homemade post peeler. Youtube has many videos of those machines. One brand name is Morbark. Treating (cold soak butt treat) which was putting posts in the tank and then soaking for 24 hours and then sizing and sorting was the easiest part. The season lasted from as soon as we could get around in the snow until bitter cold or too much snow. We also were ranching so feeding, calving, and so on meant there was very little time off. Thanksgiving, Christmas, and New Years day were close to days off since feeding only took until about noon. By the time I was an adult the work became a lot less miserable to do. I ended up off the place at about 27 years of age. Pretty much everything after that was much easier in comparison.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.