Posted by used red MN on February 05, 2022 at 10:52:46 from (75.73.112.20):
In Reply to: FWA swap posted by duanenyyboy on February 05, 2022 at 08:16:23:
Hello Duane welcome to YT. No hands on experience, but looking at the parts diagrams you have a fair task ahead of you if you decide to take this on. First thing I would do is get the drive section off that the rear of the front drive shaft pulls power from out of the transmission to make sure the gear is in place on the 684 that drives it. If you are not aware you can view the parts break downs for these tractors online. I will add a link for that, it may open to a Farmall M trans diagram, you need to choose ..Model name.. for the search type and enter 584 or 684 then search it will pop up in the list. I will say that on my iPhone it does not work the greatest. Or at least when I select a part number to see details and ultimately put it in the cart to purchase the wrong part shows up. CHNI says that it could be due to the ..cache.. in the browser but I have never had the guts to clear it. I also can give you a link to the service manual for your tractor, prefer to do that by email, log in on Modern View or will show on Classic. Hope this helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
