Posted by Texasmark on February 10, 2022 at 06:53:03 from (99.197.208.100):
In Reply to: Re: 4030 posted by BarnyardEngineering on February 10, 2022 at 04:35:07:
Funny you make that comparison.
I spent 2 years as part of the Linear Accelerator design/installation team on the Superconducting Super Collider down in Waxahachie, Tx. back in the early 90s before congress closed it. The aim for two wads of ions traveling in opposite directions around the loop, at the speed of light, was to be controlled by superconducting magnets, running at 4* Kelvin. with Cryogenic Cooling stations every 5 miles in a 54 mile circle.
The viewing towers were where they would flip a switch and cause the wads of ions to smash into each other and the scientists were there to see the Quarks, Top Quarks and other things spewing out of the collision. Cern Laboratory in Switzerland was doing and completed the same thing but in an 18 mile circle....if my memory is intact for all of this. The idea was to explore the origination of matter....see if they could figure out where everything originated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
