Posted by 560Dennis on February 20, 2022 at 07:17:50 from (71.72.187.41):
In Reply to: Weak magneto spark posted by grandpa Love on February 19, 2022 at 19:15:13:
Had a problem like that with Farmall C magneto ! , I put in new coil ,points and condenser in it as part of the maintenance, been sitting in barn for 25 or more years. After I did that the next spring the tractor acted like that. No spark I change the condenser ,been running good ever since . I would like point out I dont know for sure it was a bad condenser , I never tested the condenser ,only with a vom it seemed to work. But I dont have a condenser tester. They are cheap enough just trash it and moved on. Dont like throwing parts at a problem ,but in this case ,its what happened . And it worked . I cant prove it but new condensers are not made with the highest quality materials or processing over seas ,I feel so I say to be sure test it if possible. Like the Goodson guy Monaghan says ,if you dont measure ,your just guessing ! Guess I guessed right . Enough guessing Good luck
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
