Posted by rustred on March 17, 2022 at 09:23:56 from (74.214.153.210):
In Reply to: Dumb question posted by Old560 on March 17, 2022 at 08:11:21:
that is something i have tryed and so yes its a definite yes, tryed and true. when the crank broke on my 6.5 chevy i changed out the block with a used one from the auto wreaker.priced out new rings and they were 900.00 at the time about 20 years ago. measured the old rings in the bore and next to nothing for wear. truck had over 200,000 k on it. honed the cyl's and installed my pistons with old rings and that engine is still running. has 400,000 k on it now. also in the mid 1970's in mechanic's classes we tore down a 225 slant 6 cylinder engine to bare block. measured all components and put the engine back together with old brgs and rings. run engine on test stand all was good. then the next class would do the exact same thing. i for get how many times the instructor said these engines were apert and back together. everything had to be set to factory spec so that when he turned the key it would start right up which it did.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
