In my past experience it works pretty good. Several years ago I was custom planting for a neighbor and he ran out of seed (underestimated his acreage), sold him a bag of seed I had left over. Ran out again, so he went to the corn crib and started hand shelling some ears. By the time we got the field done, him and his wife must have shelled a bushel or so seed from the crib. When it came up you couldn't tell much difference in the corn, he thought when he picked it that fall it yielded better than any of the bought seed. I was using a finger pickup (JD 7000) planter so sizing for a plate wasn't a big concern.
I did same thing a couple years ago for a variety that was no longer available. Did a germination test myself - was about 98%. Only problem is if the corn your going to use was mechanically shelled (combine or sheller) you need to get any cracked kernels out or you will have skips. Cracked grain won't grow. Awfully hard to get all the cracked grain out with a standard cleaner. Even with some skips that field had a respectful yield.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
