Posted by andy r on April 14, 2022 at 18:15:52 from (208.126.193.44):
I posted this in implements as well, but not getting any replies. I purchased a planter and the seller kept his Precision Planting 20/20 monitor. Is the 37 pin connector from this planter that connected to his Precision Planting monitor going to work on the monitors I all ready have? I have Kinze 1000 and 2000 monitors which are Dickeyjohn and a John Deere 300 ComputerTrac Monitor. What I have learned is that Dickeyjohn monitors and John Deere branded monitors powered the harness/seed sensors a little different by putting the + and - power to different pins. An adaptor can be purchased to make them all work together. If some one could tell me that a Precision Planting monitor uses the same or different power pins as either an old Dickeyjohn/Kinze or a John Deere monitor that would help. The seed tubes on this planter are the Dickeyjohn traditional light sensors but are the 3 bulb high rate. Thanks for the help.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
