Posted by caterpillar guy on April 22, 2022 at 18:28:18 from (47.26.95.42):
In Reply to: JD 71 flex planter posted by Mjm42 on April 22, 2022 at 16:14:49:
If you get back to me with the center hole diameter the bolt /rivet pattern and size I might be able to help you out. If they just bolt on with a bolt in the center and are 5/8 you could use most any newer disk on it that is the right diameter. Looking at a couple on line it looked like it has 6 bolts maybe holding a cap on. If this is correct then the newer disks would fit from much newer planters and are around $25-35 each from Deere or aftermarket. I just got 22 of them for our planter at that price this spring. SO I know the price is close. If it has bolts to hold the disand cap on the rivets in newer model discs could be knocked out and bolts uaed to keep the original look if needed. I would also need to know diameter of the discs too. Email or phone at 1 517 202 6820 will get a message to me. Mark
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
