Posted by BarnyardEngineering on April 28, 2022 at 04:31:15 from (161.69.112.11):
In Reply to: Farmall c rod bearings posted by farmallmitch on April 27, 2022 at 09:59:57:
Quote: CVPost-farmallmitch (quoted from post at 13:24:06 04/27/22) So you are saying I should buy the standard size bearings? Which are what I actually took out of the rod bearings. I was listening to the parts guys. I dont have a mechanic were on a farm and do it ourself. Never had this problem before. I also have multiple farmall cs so Im not trying to dump a lot of time and money into it by rebuilding and machining everything. Just want it to be a nice cultivating tractor for a few acres. Do you recommend just getting the standard size bearings like what I pulled out?
Yes. Absolutely.
You NEVER put in "undersize" bearings unless you are having the crankshaft journals ground down to the new undersize dimension.
Also 1.745 is NOT .010 undersize. It is .005 undersize. .010 undersize bearings will not turn.
Again, if you are not going ot have the crank turned and ground, put in the SAME SIZE bearings that you took out. The bulk of the wear is in the bearings.
This post was edited by BarnyardEngineering on 04/28/2022 at 04:32 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
