Lots of information missing here; how deep posts were pounded, type of post wood, location of fence (what kind of weather conditions does it see), etc.
For me, I would look at the past conditions that the fence has been exposed to. I don't know what winds are like in your area, but around us it gets plenty windy. Our electric utility knows how to install power poles. And yet, many poles will angle to one side after a while. Happens when ground is wet and in high winds; not so much from ground heave.
I would assume your wood fence captures MUCH more wind than a power pole, so I'm going to HEAVILY lean towards this being your cause. Just simple maintenance due to natural events. I will guess that there is nobody to blame.
I will also suspect that whether spraying or mowing, clearing grasses/weeds from the fence is likely not going to have any bearing on what you're asking about.
Just my opinion, but an interesting question to ponder this morning. Thanks!
One last thing -- vegetation and terrain can funnel and channel wind, increasing its speed in some areas over others. I know this to be true because of our house vs. our pasture. In the open, wind is usually about 30% to 40% less than at the house. But depends on the direction of the wind and how the wind interacts with vegetation. ...We have no terrain. All flat! :shock:
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
