Re: ign. coil

Posted by Geo-TH,In on June 16, 2022 at 11:42:11 from (50.127.66.48):

In Reply to: Re: ign. coil posted by JMOR on June 16, 2022 at 10:23:56:

Jessie,
That starter will require a little redneck engineering to bypass the ballast
resistor;
You will need to attach a NO switch to the control rod so when you pull on the rod,
the switch closes and applies the full 12v to the coil. No diode needed.

Or you could remove the cover on the end of the starter. Attach the wire where the
power comes. Then run it to a diode..

Going to need to get creative using that old starter.. May require taking the starter
apart to get ahold of the power in wire..

Replies:

Add a Reply! You must be Logged In to Post Name: E-Mail: Subject: (avoid special characters) Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video Embed: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks. No political comments, hate speech or bigotry of any kind will be tolerated. Violations will be removed and posting privileges may be permanently revoked without notice.   Advanced Posting Tools   Select Gallery Photo  Attach Serial No List  Return to Post  Upload Photos/Videos Choose Files from your local computer Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]