Posted by Steve@Advance on June 17, 2022 at 09:39:45 from (99.190.215.237):
In Reply to: Your opinion on plugs posted by 710ltd2002 on June 17, 2022 at 06:19:44:
The debate over plug brands will never end or prove anything.
Plug life is more dependent on the engine condition, work load, and fuel mixture.
Always use the correct plug as far as the size, reach, and sealing surface (gasket or taper seat). But the heat range can be adjusted for the particular application. On a healthy engine that gets used as intended, the factory recommended plug is a good starting place and most likely will be the ones you stay with.
If the engine runs under a heavy load, possibly with less than desirable fuel (a problem from the past) then colder plugs will be a better choice.
An engine that gets little use, frequent starts, not run up to temperature, or as it ages begins to consume oil, then it needs hotter heat range plugs.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
