Posted by 4020_guy on June 22, 2022 at 10:46:31 from (68.171.72.108):
I would like to remove the Robert Bosch injectors from my 7520 JD tractor. They have the 12 point nuts at the bottom of the injector to push them out or pull them in. I have used a box end wrench on my 4230 as the injector was round after removing the leak off pipe. Only thing with these ones, the injector is Y shaped at the top so a boxed end wrench won't go over the top. Manual said to use a JDE 69 wrench to remove. Would these still be available or could one just cut a piece from a box end wrench? I'm thinking there may be a sticking injector as there is kind of fluttering on acceleration and fire balls up the pipe on de-acceleration. I had a leaking injector line that I replaced and it started shortly after that. I cleaned the injector and pump area with brake clean and air about 5 times and removed the alternator and all the lines and stuff. The new line was in a sealed plastic bag and had plastic plugs screwed in the ends. With all the stuff removed it was a easy fit for the line. Didn't have to twist and rotate and rotate and twist again to install. Thought it might be the turbo but I think it is ok. Any other thoughts. Thanks for now.......Ron
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
