Posted by DR. EVIL on July 03, 2022 at 06:44:20 from (174.192.73.161):
In Reply to: Square baling photos posted by greg oliver on July 03, 2022 at 05:00:00:
Our baling crew was two men and a small boy driving the neighbor's tractor pulling the baler since I was 8-9 years old, neighbor who owned the baler loaded the loads, Dad hauled in and unloaded in our barns, we fed the bales right where they stopped rolling down the pile of bales. When we baled for the neighbor who owned the baler jobs were all the same except a neighbor helped stacking the hay in the barn. We baled for that other neighbor some too, little straw, some hay. Dad owned a 50 ft Deere bale conveyor everybody used ONLY IF Dad went with it. He didn't even like Me to help him unload. The last time Dad and I baled was 20 acres of 2nd or 3rd cutting alfalfa I cut, I raked, Dad sent me after the baler, the old IH 55-T engine powered baler was replaced with a much newer #37 IH PTO baler. We had two racks, did 6 or 8 loads that day just the 2 of us. The Super H ran that baler just great in 2nd gear. When I raked for the 55-T I raked up MONSTER windows because I could idle down or clutch the tractor pulling the baler. Two rake swaths per window with the #37 was great. Neighbor across the road sold 40 acres of hay to a cattle sale barn in town one summer. Hauled it the 10 miles to town in livestock semi-trailers. Dad opted out of the project, was Me and neighbor on the baler, neighbor kid stacking IN the livestock trailer. Not hard to see why big round hay bales are so popular!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.