Posted by showcrop on July 15, 2022 at 03:37:12 from (75.68.37.174):
In Reply to: 1968 Ford 8000 posted by lilybwithtwins on July 14, 2022 at 05:41:09:
Quote: lilybwithtwins (quoted from post at 14:47:30 07/14/22) Yes it is! Have you pulled here?
Yes, I have!
https://www.youtube.com/watch?v=C1r4VsG1b8A
This was obviously a transfer sled pull as opposed to stoneboat. There were a few of the stoneboat guys there though. I knew about your 8000 and about breaking the axle. As you probably know it is on youtube. I have also hooked at Cliff Clark's in Williamsburg and at Bolton Fair. I am in southern NH.
You should check with Jason or Corey at Forrester's New Holland in Chambersburg PA. They pull Ford/NewHollands all over the country, and if there is an axle change-out like your twins want to do they would know about it. I sent an email to a puller from down your way that would probably know about how the axle was repaired.
This post was edited by showcrop on 07/15/2022 at 03:42 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
