Posted by Steve@Advance on August 14, 2022 at 06:49:06 from (99.190.215.237):
In Reply to: Farmall 400 md? posted by Warhead13 on August 13, 2022 at 19:30:20:
Being it's new to you, I would run it a while, drive it around, put a load on it if possible. Watch the temperature and coolant level, check out the rest of the functions, listen, feel, observe, make a list of everything you find.
Get an idea what all it will take to get it where you want it. If it has to come apart, better to do everything at once that take it apart again!
By then you will have a better idea of the water out the exhaust. If it continues even when warmed up, mystery coolant loss (but don't overfill it, keep the level just above the core openings), misfire, coolant in the oil, blowing coolant out the radiator, then there is a problem.
You can also run a combustion gas detector test, a chemical that changes color when it detects combustion gasses in the radiator.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
