Posted by caterpillar guy on August 23, 2022 at 02:53:10 from (47.26.95.42):
In Reply to: Good deal? posted by YmmijG on August 22, 2022 at 18:22:19:
I think you will be sadly disappointed with any of those smaller fords with a loader on then. The front ends are not designed for the weight of loaders let alone the extra load in the bucket. Then steering will become a problem for you with the weight. If you want a loader tractor get something bigger and a bit newer. More like the 70's or 80's model tractors with heavier front axles and heavier tractor. It is like any other piece of equipment some are suited for the job and some are not most of those older fords were not suited for loaders. The tractors of the 40's 50's and even some into the early 60's, loaders were an after thought. The tractors didn't have the hydraulics for loaders to run them well. Were slow lifting lower pressure, so had big cylinders to be able to do the lifting and front spindles and axles were not designed and up to the job very well. Loaders and tractors really came into use and matching up components in the later 60's and 70's up to this day.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
