Posted by paul on August 25, 2022 at 08:36:43 from (66.60.209.84):
In Reply to: Mini balers posted by Skipper on August 25, 2022 at 05:34:29:
As the others mention, Id sooner get a good solid older small square baler.
The mini round balers dont have a lot of parts and support around. They cost a fair amount. They kind of miss the point of efficiency on every level.... a big round bale can store outside, you lose a few inches to weathering but most of the bale stays good. You can move a lot of hay with a big round bale, easy to clear out a whole field with a good bobcat and trailer. You dont use much twine or wrap on the bigger round bales, more savings.
The mini round bales take forever to bale a whole field, take forever to chase them down gathering them, and then you need to store them, how do you stack the little devils......
They really defeat the point and purpose of a good big round bale.
If you want small stuff, go with the small square bales. There are many options of accumulators, baskets, or throwers to make handling them easier. If you sell some people are familiar with them and how to handle and store them at home.
Those mini rounds are just awkward.
Im sure there are many that get along fine with them. If its what a person wants then good deal! But do think it through. They arent the best option for everyone.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
