Posted by 1206SWMO on August 28, 2022 at 17:23:57 from (75.105.99.91):
I was up real early Saturday morning to attend the Larry Clover estate sale..It was a nearly 2 hour drive over to Sycamore,Kansas...I left at 5:45 AM...I promptly got woke up after driving one mile south on 4 lane I-49....Here came a north bound car in the south bound lane..Larry had antique tractor pulled for around 40 plus years and was known far and wide..He had received a plaque for pulling at all 25 Kansas State Fair pulls...He was a real nice guy..There were 59 tractors and I'll bet at least 20-25 had been pulled over the years..The family kept his Oliver 60 puller and several others.
Its taking forever to load pictures so I might not get them all this evening?Check back in the morning.
This nice running 1950 model Oliver 77 sold for $4,000
The running 1938 John Deere G sold for $7,100.. Wow
Running 1959 model 630 JD with loader sold for $3,200.
Running 1937 John Deere B sold for $2,500.
John Deere 70 LP sold for $1,300
5 pictures is all that it will let me load..Be back with more sometime this evening and tomorrow morning.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
